• Fill all dishwasher detergent dispensers completely. For heavily soiled dishes or hard water, use slightly more detergent. Use less detergent for very soft water.
• Run dishwasher. Optimal water temperature is 140° F.

1. Check whether your dishwasher has a built-in liquid rinse agent dispenser, usually located near the detergent cup(s).

2. Fill your rinse agent dispenser with FINISH® JET-DRY® Rinse Agent. Wipe up any spilled product.

3. FINISH® JET-DRY® Rinse Agent is automatically released in the rinse cycle every time your dishwasher runs.

Note: If your dishwasher does not have a built-in rinse agent dispenser. Use the FINISH® JET-DRY® Solid Rinse Agent which clips to the top rack of your dishwasher for sparkling clean results with every wash.

Spots and film form in your dishwasher's rinse cycle, when detergents are already down the drain. FINISH® JET-DRY® Rinse Agent works in the rinse cycle, lowering the surface tension of water and causing it to sheet. Better rinsing results in less spots and film.

1. Check whether your dishwasher has a built-in liquid rinse agent dispenser, usually located near the detergent cup(s).

2. Fill your rinse agent dispenser with [FINISH® JET-DRY® TURBO DRY®. Wipe up any spilled product.

3. FINISH® JET-DRY® TURBO DRY® is automatically released every time your dishwasher runs.

4. Discard your old dish towel. With FINISH® JET-DRY® TURBO DRY®, the dishes are done!

1. DO NOT REMOVE CAP. Remove sticker from top of bottle.

2. Make sure your dishwasher is empty.

3. Place the bottle upside down inside the silverware basket or in a secure position.

4. Do not use any soap or dishwasher detergent.

5. Close dishwasher door, then set dishwasher to heavy wash (pots & pans, sani, etc) cycle. Start dishwasher.

6. After full cycle is complete and dishwasher is off, remove bottle and discard.

7. For heavy build up a 2nd application may be necessary. For best results, use once a month.

1. Pour 1/4 cup (4 tbsp) of GLASS MAGIC® into the bottom of your dishwasher.

2. Fill the dishwasher detergent dispenser with your favorite detergent and run through a normal wash cycle.

3. For optimal results, fill your liquid rinse agent dispenser with JET-DRY® Rinse Agent for spot removal during the rinse cycle.

Note: If glasses are heavily filmed or spotted, wash using 1/2 cup (8 tbsp) of GLASS MAGIC® for several loads or until glasses are crystal clear.

Your dishwashing detergent should be stored in a dry environment. If you are using powders, be careful to close the spout after each use to help keep the product dry (and to avoid spills!). Like all cleaning products, store your detergent out of the reach of children.

It isn't necessary to rinse your dishes, just remove excess foods such as bones and pits.

The FINISH® tab/pac goes in the compartment with the cover.

• Make sure that your dishwasher is loaded properly. Ensure you have enough FINISH® JET-DRY® Rinse Agent for each wash. Try FINISH® JET-DRY® TURBO DRY® for amazingly dry dishes.
• Rinse agent dosage may be too low; Adjust the setting for the rinse aid dosage.
• The dish may have been removed too early from the dishwasher (cycle was not finished completely).

Yes, this product is biodegradable.

All FINISH® automatic dishwashing products are safe for septic systems.

FINISH® QUANTUMATIC™ is a revolutionary new dishwasher detergent dispenser and refill system that delivers brilliant cleaning performance automatically for 12 washes. There are no products comparable to QUANTUMATIC™ on the market.

Click here to visit our contact page.